EasyManuals Logo

Cisco IE-3000-8TC Command Reference

Cisco IE-3000-8TC
802 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #595 background imageLoading...
Page #595 background image
2-569
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
switchport port-security
switchport port-security
Use the switchport port-security interface configuration command without keywords to enable port
security on the interface. Use the keywords to configure secure MAC addresses, sticky MAC address
learning, a maximum number of secure MAC addresses, or the violation mode. Use the no form of this
command to disable port security or to set the parameters to their default states.
switchport port-security [mac-address mac-address [vlan {vlan-id | {access | voice}}] |
mac-address sticky [mac-address | vlan {vlan-id | {access | voice}}]] [maximum value [vlan
{vlan-list | {access | voice}}]]
no switchport port-security [mac-address mac-address [vlan {vlan-id | {access | voice}}] |
mac-address sticky [mac-address | vlan {vlan-id | {access | voice}}]] [maximum value [vlan
{vlan-list | {access | voice}}]]
switchport port-security [aging] [violation {protect | restrict | shutdown | shutdown vlan}]
no switchport port-security [aging] [violation {protect | restrict | shutdown | shutdown vlan}]
Syntax Description aging (Optional) See the switchport port-security aging command.
mac-address mac-address (Optional) Specify a secure MAC address for the interface by entering
a 48-bit MAC address. You can add additional secure MAC addresses
up to the maximum value configured.
vlan vlan-id (Optional) On a trunk port only, specify the VLAN ID and the MAC
address. If no VLAN ID is specified, the native VLAN is used.
vlan access (Optional) On an access port only, specify the VLAN as an access
VLAN.
vlan voice (Optional) On an access port only, specify the VLAN as a voice VLAN.
Note The voice keyword is available only if voice VLAN is
configured on a port and if that port is not the access VLAN.
mac-address sticky
[mac-address]
(Optional) Enable the interface for sticky learning by entering only the
mac-address sticky keywords. When sticky learning is enabled, the
interface adds all secure MAC addresses that are dynamically learned to
the running configuration and converts these addresses to sticky secure
MAC addresses.
(Optional) Enter a mac-address to specify a sticky secure MAC address.
maximum value (Optional) Set the maximum number of secure MAC addresses for the
interface.The maximum number of secure MAC addresses that you can
configure on a switch is set by the maximum number of available MAC
addresses allowed in the system. This number represents the total of
available MAC addresses, including those used for other Layer 2
functions and any other secure MAC addresses configured on interfaces.
The default setting is 1.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals