Cisco IE-3000-8TC Command Reference

B-76
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug vqpc
debug vqpc
Use the debug vqpc privileged EXEC command to enable debugging of the VLAN Query Protocol
(VQP) client. Use the no form of this command to disable debugging.
debug vqpc [all | cli | events | learn | packet]
no debug vqpc [all | cli | events | learn | packet]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug vqpc command is the same as the no debug vqpc command.
Related Commands
all (Optional) Display all VQP client debug messages.
cli (Optional) Display the VQP client command-line interface (CLI) debug
messages.
events (Optional) Display VQP client event debug messages.
learn (Optional) Display VQP client address learning debug messages.
packet (Optional) Display VQP client packet information debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes