Cisco IE-3000-8TC Command Reference

B-46
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform snmp
debug platform snmp
Use the debug platform snmp privileged EXEC command to enable debugging of the
platform-dependent Simple Network Management Protocol (SNMP) software. Use the no form of this
command to disable debugging.
debug platform snmp
no debug platform snmp
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform snmp command is the same as the no debug platform snmp command.
Related Commands
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes