Cisco IE-3000-8TC Command Reference

2-502
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
spanning-tree backbonefast
spanning-tree backbonefast
Use the spanning-tree backbonefast global configuration command to enable the BackboneFast
feature. Use the no form of the command to return to the default setting.
spanning-tree backbonefast
no spanning-tree backbonefast
Syntax Description This command has no arguments or keywords.
Defaults BackboneFast is disabled.
Command Modes Global configuration
Command History
Usage Guidelines You can configure the BackboneFast feature for rapid PVST+ or for multiple spanning-tree (MST) mode,
but the feature remains disabled (inactive) until you change the spanning-tree mode to PVST+.
BackboneFast starts when a root port or blocked port on a switch receives inferior BPDUs from its
designated switch. An inferior BPDU identifies a switch that declares itself as both the root bridge and
the designated switch. When a switch receives an inferior BPDU, it means that a link to which the switch
is not directly connected (an indirect link) has failed (that is, the designated switch has lost its connection
to the root switch. If there are alternate paths to the root switch, BackboneFast causes the maximum
aging time on the interfaces on which it received the inferior BPDU to expire and allows a blocked port
to move immediately to the listening state. BackboneFast then transitions the interface to the forwarding
state. For more information, see the software configuration guide for this release.
Enable BackboneFast on all supported switches to allow the detection of indirect link failures and to start
the spanning-tree reconfiguration sooner.
Examples This example shows how to enable BackboneFast on the switch:
Switch(config)# spanning-tree backbonefast
You can verify your setting by entering the show spanning-tree summary privileged EXEC command.
Related Commands
Release Modification
12.2(44)EX This command was introduced.
Command Description
show spanning-tree summary Displays a summary of the spanning-tree interface states.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes