Cisco IE-3000-8TC Command Reference

2-113
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
errdisable recovery cause small-frame
errdisable recovery cause small-frame
Use the errdisable recovery cause small-frame global configuration command on the switch to enable
the recovery timer for ports to be automatically re-enabled after they are error disabled by the arrival of
small frames. Use the no form of this command to return to the default setting.
errdisable recovery cause small-frame
no errdisable recovery cause small-frame
Syntax Description This command has no arguments or keywords.
Defaults This feature is disabled.
Command Modes Global configuration
Command History
Usage Guidelines This command enables the recovery timer for error-disabled ports. You configure the recovery time by
using the errdisable recovery interval interval interface configuration command.
Examples This example shows how to set the recovery timer:
Switch(config)# errdisable recovery cause small-frame
You can verify your setting by entering the show interfaces user EXEC command.
Related Commands
Release Modification
12.2(44)EX This command was introduced.
Command Description
errdisable detect cause small-frame Allows any switch port to be put into the error-disabled
state if an incoming frame is smaller than the configured
minimum size and arrives at the specified rate (threshold).
show interfaces Displays the interface settings on the switch, including
input and output flow control.
small violation-rate Configures the size for an incoming (small) frame to cause
a port to be put into the error-disabled state.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes