Cisco IE-3000-8TC Command Reference

2-105
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
dot1x timeout
dot1x timeout
Use the dot1x timeout interface configuration command to set IEEE 802.1x timers. Use the no form of
this command to return to the default setting.
dot1x timeout {quiet-period seconds | ratelimit-period seconds | reauth-period {seconds |
server} | server-timeout seconds | supp-timeout seconds | tx-period seconds}
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
Syntax Description
Defaults These are the default settings:
reauth-period is 3600 seconds.
quiet-period is 60 seconds.
tx-period is 5 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
rate-limit is 1 second.
Command Modes Interface configuration
Command History
quiet-period seconds Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
ratelimit-period seconds Number of seconds that the switch ignores Extensible Authentication
Protocol over LAN (EAPOL) packets from clients that have been
successfully authenticated during this duration. The range is 1 to 65535.
reauth-period {seconds |
server}
Set the number of seconds between re-authentication attempts.
The keywords have these meanings:
• seconds—Sets the number of seconds from 1 to 65535; the default is
3600
seconds.
• server—Sets the number of seconds as the value of the
Session-Timeout RADIUS attribute (Attribute[27]).
server-timeout seconds Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server. The range is 30 to 65535.
supp-timeout seconds Number of seconds that the switch waits for the retransmission of packets
by the switch to the IEEE 802.1x client. The range is 30 to 65535.
tx-period seconds Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the
request. The range is 1 to 65535.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes