B-71
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug sw-vlan notification
debug sw-vlan notification
Use the debug sw-vlan notification privileged EXEC command to enable debugging of the activation
and deactivation of Inter-Link Switch (ISL) VLAN IDs. Use the no form of this command to disable
debugging.
debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange | linkchange |
modechange | pruningcfgchange | statechange}
no debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange |
linkchange
| modechange | pruningcfgchange | statechange}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug sw-vlan notification command is the same as the no debug sw-vlan notification
command.
Related Commands
accfwdchange Display debug messages for VLAN manager notification of aggregated
access interface spanning-tree forward changes.
allowedvlancfgchange Display debug messages for VLAN manager notification of changes to the
allowed VLAN configuration.
fwdchange Display debug messages for VLAN manager notification of spanning-tree
forwarding changes.
linkchange Display debug messages for VLAN manager notification of interface
link-state changes.
modechange Display debug messages for VLAN manager notification of interface mode
changes.
pruningcfgchange Display debug messages for VLAN manager notification of changes to the
pruning configuration.
statechange Display debug messages for VLAN manager notification of interface state
changes.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show vlan Displays the parameters for all configured VLANs or one VLAN (if the
VLAN name or ID is specified) in the administrative domain.