Cisco IE-3000-8TC Command Reference

2-59
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
cluster discovery hop-count
cluster discovery hop-count
Use the cluster discovery hop-count global configuration command on the cluster command switch to
set the hop-count limit for extended discovery of candidate switches. Use the no form of this command
to return to the default setting.
cluster discovery hop-count number
no cluster discovery hop-count
Syntax Description
Defaults The hop count is set to 3.
Command Modes Global configuration
Command History
Usage Guidelines This command is available only on the cluster command switch. This command does not operate on
cluster member switches.
If the hop count is set to 1, it disables extended discovery. The cluster command switch discovers only
candidates that are one hop from the edge of the cluster. The edge of the cluster is the point between the
last discovered cluster member switch and the first discovered candidate switch.
Examples This example shows how to set hop count limit to 4. This command is executed on the cluster command
switch.
Switch(config)# cluster discovery hop-count 4
You can verify your setting by entering the show cluster privileged EXEC command.
Related Commands
number Number of hops from the cluster edge that the cluster command switch limits
the discovery of candidates. The range is 1 to 7.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show cluster Displays the cluster status and a summary of the cluster to which the
switch belongs.
show cluster candidates Displays a list of candidate switches.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes