Cisco IE-3000-8TC Command Reference

2-17
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
archive tar
archive tar
Use the archive tar privileged EXEC command to create a tar file, list files in a tar file, or extract the
files from a tar file.
archive tar {/create destination-url flash:/file-url} | {/table source-url} | {/xtract source-url
flash:/file-url [dir/file...]}
Syntax Description /create destination-url
flash:/file-url
Create a new tar file on the local or network file system.
For destination-url, specify the destination URL alias for the local or
network file system and the name of the tar file to create. These options
are supported:
• The syntax for the local flash filesystem:
flash:
• The syntax for the FTP:
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
• The syntax for an HTTP server:
http://[[username:password]@]{hostname |
host-ip}[/directory]/image-name.tar
• The syntax for a secure HTTP server:
https://[[username:password]@]{hostname |
host-ip}[/directory]/image-name.tar
• The syntax for the Remote Copy Protocol (RCP) is:
rcp:[[//username@location]/directory]/tar-filename.tar
• The syntax for the TFTP:
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file to be created.
For flash:/file-url, specify the location on the local flash file system from
which the new tar file is created.
An optional list of files or directories within the source directory can be
specified to write to the new tar file. If none are specified, all files and
directories at this level are written to the newly created tar file.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes