Cisco IE-3000-8TC Command Reference

2-82
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
dot1x control-direction
dot1x control-direction
Use the dot1x control-direction interface configuration command to enable the IEEE 802.1x
authentication with the wake-on-LAN (WoL) feature and to configure the port control as unidirectional
or bidirectional. Use the no form of this command to return to the default setting.
dot1x control-direction {both | in}
no dot1x control-direction
Syntax Description
Defaults The port is in bidirectional mode.
Command Modes Interface configuration
Command History
Usage Guidelines Use the both keyword or the no form of this command to return to the default setting, bidirectional
mode.
For more information about WoL, see the “Using IEEE 802.1x Authentication with Wake-on-LAN”
section in the “Configuring IEEE
802.1x Port-Based Authentication” chapter in the software
configuration guide.
Examples This example shows how to enable unidirectional control:
Switch(config-if)# dot1x control-direction in
This example shows how to enable bidirectional control:
Switch(config-if)# dot1x control-direction both
You can verify your settings by entering the show dot1x all privileged EXEC command.
The show dot1x all privileged EXEC command output is the same for all switches except for the port
names and the state of the port. If a host is attached to the port but is not yet authenticated, a display
similar to this appears:
Supplicant MAC 0002.b39a.9275
AuthSM State = CONNECTING
BendSM State = IDLE
PortStatus = UNAUTHORIZED
both Enable bidirectional control on port. The port cannot receive
packets from or send packets to the host.
in Enable unidirectional control on port. The port can send packets to
the host but cannot receive packets from the host.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes