Cisco IE-3000-8TC Command Reference

2-88
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
dot1x default
dot1x default
Use the dot1x default interface configuration command to reset the IEEE 802.1x parameters to their
default values.
dot1x default
Syntax Description This command has no arguments or keywords.
Defaults These are the default values:
• The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).
• The number of seconds between re-authentication attempts is 3600 seconds.
• The periodic re-authentication is disabled.
• The quiet period is 60 seconds.
• The retransmission time is 30 seconds.
• The maximum retransmission number is 2 times.
• The host mode is single host.
• The client timeout period is 30 seconds.
• The authentication server timeout period is 30 seconds.
Command Modes Interface configuration
Command History
Examples This example shows how to reset the IEEE 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Release Modification
12.2(44)EX This command was introduced.
Command Description
show dot1x [interface interface-id] Displays IEEE 802.1x status for the specified port.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes