Cisco IE-3000-8TC Command Reference

2-398
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show lacp
show lacp
Use the show lacp user EXEC command to display Link Aggregation Control Protocol (LACP)
channel-group information.
show lacp [channel-group-number] {counters | internal | neighbor | sys-id} [ | {begin | exclude |
include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines You can enter any show lacp command to display the active channel-group information. To display
specific channel information, enter the show lacp command with a channel-group number.
If you do not specify a channel group, information for all channel groups appears.
You can enter the channel-group-number option to specify a channel group for all keywords except
sys-id.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show lacp counters user EXEC command. Table 2-27 describes
the fields in the display.
Switch> show lacp counters
LACPDUs Marker Marker Response LACPDUs
Port Sent Recv Sent Recv Sent Recv Pkts Err
---------------------------------------------------------------------
Channel group:1
Gi1/1 19 10 0 0 0 0 0
Gi1/2 14 6 0 0 0 0 0
channel-group-number (Optional) Number of the channel group. The range is 1 to 6.
counters Display traffic information.
internal Display internal information.
neighbor Display neighbor information.
sys-id Display the system identifier that is being used by LACP. The system
identifier is made up of the LACP system priority and the switch MAC
address.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes