Cisco IE-3000-8TC Command Reference

B-25
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform acl
debug platform acl
Use the debug platform acl privileged EXEC command to enable debugging of the access control list
(ACL) manager. Use the no form of this command to disable debugging.
debug platform acl {all | exit | label | main | warn}
no debug platform acl {all | exit | label | main | warn}
Syntax Description
Note Though visible in the command-line help strings, the racl, stack, vacl, and vlmap keywords are not
supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform acl command is the same as the no debug platform acl command.
Related Commands
all Display all ACL manager debug messages.
exit Display ACL exit-related debug messages.
label Display ACL label-related debug messages.
main Display the main or important ACL debug messages.
warn Display ACL warning-related debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes