EasyManuals Logo

Cisco IE-3000-8TC Command Reference

Cisco IE-3000-8TC
802 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
2-6
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
alarm facility fcs-hysteresis
alarm facility fcs-hysteresis
Use the alarm facility fcs-hysteresis global configuration command to set the frame check sequence
(FCS) error hysteresis threshold as a percentage of fluctuation from the FCS bit-error rate. Use the no
form of this command to set the FCS error hysteresis threshold to its default value.
alarm facility fcs-hysteresis percentage
no alarm facility fcs-hysteresis percentage
Syntax Description
Defaults The default threshold-value is 10 percent.
Command Modes Global configuration
Command History
Usage Guidelines Set a hysteresis threshold to cause an alarm to trigger when the FCS bit-error rate fluctuates near the
configured rate.
You set the FCS hysteresis threshold for all ports on the switch. You set the FCS error rate on a per-port
basis by using the fcs-threshold interface configuration command.
If the threshold is not the default, it appears in the output of the show running-config privileged EXEC
command.
Examples This example shows how to set the FCS error hysteresis to 5 percent. The alarm is not triggered unless
the bit error rate is more than 5 percent from the configured FCS bit-error rate.
Switch(config)# alarm facility fcs-hysteresis 5
Related Commands
percentage Hysteresis threshold fluctuation. The range is 1 to 10 percent.
Release Modification
12.2(44)EX This command was introduced.
Command Description
fcs-threshold Sets an FCS error rate for an interface.
show running-config Displays the running configuration on the switch, including FCS hysteresis
threshold if it is not set at the default.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals