EasyManuals Logo

Cisco IE-3000-8TC Command Reference

Cisco IE-3000-8TC
802 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #148 background imageLoading...
Page #148 background image
2-122
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
interface port-channel
interface port-channel
Use the interface port-channel global configuration command to access or create the port-channel
logical interface. Use the no form of this command to remove the port-channel.
interface port-channel port-channel-number
no interface port-channel port-channel-number
Syntax Description
Defaults No port-channel logical interfaces are defined.
Command Modes Global configuration
Command History
Usage Guidelines For Layer 2 EtherChannels, you do not have to create a port-channel interface first before assigning a
physical port to a channel group. Instead, you can use the channel-group interface configuration
command. It automatically creates the port-channel interface when the channel group gets its first
physical port. If you create the port-channel interface first, the channel-group-number can be the same
as the port-channel-number, or you can use a new number. If you use a new number, the channel-group
command dynamically creates a new port channel.
Only one port channel in a channel group is allowed.
Follow these guidelines when you use the interface port-channel command:
If you want to use the Cisco Discovery Protocol (CDP), you must configure it only on the physical
port and not on the port-channel interface.
Do not configure a port that is an active member of an EtherChannel as an IEEE 802.1x port. If
IEEE
802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join the
EtherChannel.
For a complete list of configuration guidelines, see the “Configuring EtherChannels” chapter in the
software configuration guide for this release.
Examples This example shows how to create a port-channel interface with a port channel number of 5:
Switch(config)# interface port-channel 5
You can verify your setting by entering the show running-config privileged EXEC or show
etherchannel channel-group-number detail privileged EXEC command.
port-channel-number Port-channel number. The range is 1 to 6.
Release Modification
12.2(44)EX This command was introduced.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals