2-13
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
alarm relay-mode
alarm relay-mode
Use the alarm relay-mode global configuration command to set the alarm relay mode for the switch to
positive or negative. Use the no form of the command to set the alarm relay mode to the default mode.
alarm relay-mode {negative}
no alarm relay-mode {negative}
Syntax Description
Defaults By default, the alarm relays are in positive mode when they are open. When there is no power to the
switch, all alarm relays are open. The alarm relays close when one or more alarm events are detected.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to invert the behavior of the alarm relays. When the alarm relay mode is set to
negative, alarm relays are normally closed. When one or more alarm events are detected, the appropriate
alarm relay opens.
Examples This example shows how to set the alarm relays to negative mode:
Switch(config)# alarm relay-mode negative
Related Commands
negative Set the alarm relay mode to negative.
Release Modification
12.2(44)EX This command was introduced.
Command Description
alarm profile (global
configuration)
Creates or identifies an alarm profile and enters alarm-profile configuration
mode.
show alarm profile Displays all alarm profiles or a specified alarm profile and lists the interfaces
to which each profile is attached.
show alarm settings Displays environmental alarm settings and options.