Cisco IE-3000-8TC Command Reference

B-36
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform matm
debug platform matm
Use the debug platform matm privileged EXEC command to enable debugging of platform-dependent
MAC address management. Use the no form of this command to disable debugging.
debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address | warnings}
no debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address |
warnings}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform matm command is the same as the no debug platform matm command.
Related Commands
aging Display MAC address aging debug messages.
all Display all platform MAC address management event debug messages.
ec-aging Display EtherChannel address aging-related debug messages.
errors Display MAC address management error messages.
learning Display MAC address management address-learning debug messages.
rpc Display MAC address management remote procedure call (RPC) related debug
messages.
secure-address Display MAC address management secure address learning debug messages.
warning Display MAC address management warning messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
debug matm Displays information about platform-independent MAC address management.
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes