Cisco IE-3000-8TC Command Reference

B-10
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug eap
debug eap
Use the debug eap privileged EXEC command to enable debugging of the Extensible Authentication
Protocol (EAP) activity. Use the no form of this command to disable debugging.
debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
no debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
Related Commands
all Display all EAP debug messages.
authenticator Display authenticator debug messages.
errors Display EAP error debug messages.
events Display EAP event debug messages.
md5 Display EAP-MD5 debug messages.
packets Display EAP packet debug messages.
peer Display EAP peer debug messages.
sm Display EAP state-machine related-events debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show eap Displays EAP registration and session information for the switch or for the
specified port.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes