Cisco IE-3000-8TC Command Reference

2-65
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
cluster outside-interface
cluster outside-interface
Use the cluster outside-interface global configuration command to configure the outside interface for
cluster Network Address Translation (NAT) so that a member without an IP address can communicate
with devices outside the cluster. Use the no form of this command to return to the default setting.
cluster outside-interface interface-id
no cluster outside-interface
Syntax Description
Defaults The default outside interface is automatically selected by the cluster command switch.
Command Modes Global configuration
Command History
Usage Guidelines Enter this command only on the cluster command switch. If you enter this command on a cluster member
switch, an error message appears.
Examples This example shows how to set the outside interface to VLAN 1:
Switch(config)# cluster outside-interface vlan 1
You can verify your setting by entering the show running-config privileged EXEC command.
Related Commands
interface-id Interface to serve as the outside interface. Valid interfaces include
physical interfaces, port-channels, or VLANs. The port-channel
range is 1 to 6. The VLAN range is 1 to 4094.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show running-config Displays the current operating configuration. For syntax information,
select the Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes