Cisco IE-3000-8TC Command Reference

2-301
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
setup express
setup express
Use the setup express global configuration command to enable Express Setup mode. Use the no form
of this command to disable Express Setup mode.
setup express
no setup express
Syntax Description This command has no arguments or keywords.
Defaults Express Setup is enabled.
Command Modes Global configuration
Command History
Usage Guidelines When Express Setup is enabled on a new (unconfigured) switch, pressing the Express Setup button for
2 seconds activates Express Setup. You can access the switch through an Ethernet port by using the IP
address 10.0.0.1 and then can configure the switch with the web-based Express Setup program or the
command-line interface (CLI)-based setup program.
When you press the Express Setup button for 2 seconds on a configured switch, the LEDs below the
Express Setup button start blinking. If you press the Express Setup button for a total of 10 seconds, the
switch configuration is deleted, and the switch reboots. The switch can then be configured like a new
switch, either through the web-based Express Setup program or the CLI-based setup program.
Note As soon as you make any change to the switch configuration (including entering no at the beginning of
the CLI-based setup program), configuration by Express Setup is no longer available. You can only run
Express Setup again by pressing the Express Setup button for 10 seconds. This deletes the switch
configuration and reboots the switch.
If Express Setup is active on the switch, entering the write memory or copy running-configuration
startup-configuration privileged EXEC commands deactivates Express Setup. The IP address 10.0.0.1
is no longer valid on the switch, and your connection using this IP address ends.
The primary purpose of the no setup express command is to prevent someone from deleting the switch
configuration by pressing the Mode button for 10 seconds.
Examples This example shows how to enable Express Setup mode:
Switch(config)# setup express
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes