Cisco IE-3000-8TC Command Reference

2-302
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
setup express
You can verify that Express Setup mode is enabled by pressing the Express Setup button:
• On an unconfigured switch, the LEDs below the Express Setup button turn solid green after 3
seconds.
• On a configured switch, the mode LEDs begin blinking after 2 seconds and turn solid green after 10
seconds.
Caution If you hold the Express Setup button down for a total of 10 seconds, the configuration is deleted, and the
switch reboots.
This example shows how to disable Express Setup mode:
Switch(config)# no setup express
You can verify that Express Setup mode is disabled by pressing the Express Setup button. The LEDs do
not turn solid green or begin blinking green if Express Setup mode is not enabled on the switch.
Related Commands Command Description
show setup express Displays if Express Setup mode is active.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes