Cisco IE-3000-8TC Command Reference

B-48
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform supervisor-asic
debug platform supervisor-asic
Use the debug platform supervisor-asic privileged EXEC command to enable debugging of the
supervisor application-specific integrated circuit (ASIC). Use the no form of this command to disable
debugging.
debug platform supervisor-asic {all | errors | receive | send}
no debug platform supervisor-asic {all | errors | receive | send}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform supervisor-asic command is the same as the no debug platform
supervisor-asic command.
Related Commands
all Display all supervisor-ASIC event debug messages.
errors Display the supervisor-ASIC error debug messages.
receive Display the supervisor-ASIC receive debug messages.
send Display the supervisor-ASIC send debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes