Cisco IE-3000-8TC Command Reference

B-68
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug sw-vlan
debug sw-vlan
Use the debug sw-vlan privileged EXEC command to enable debugging of VLAN manager activities.
Use the no form of this command to disable debugging.
debug sw-vlan {badpmcookies | cfg-vlan {bootup | cli} | events | ifs | management | mapping |
notification | packets | redundancy | registries | vtp}
no debug sw-vlan {badpmcookies | cfg-vlan {bootup | cli} | events | ifs | management | mapping
| notification | packets | redundancy | registries | vtp}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug sw-vlan command is the same as the no debug sw-vlan command.
badpmcookies Display debug messages for VLAN manager incidents of bad port manager
cookies.
cfg-vlan {bootup | cli} Display config-vlan debug messages. The keywords have these meanings:
• bootup—Display messages when the switch is booting up.
• cli—Display messages when the command-line interface (CLI) is in
config-vlan mode.
events Display debug messages for VLAN manager events.
ifs See the debug sw-vlan ifs command.
management Display debug messages for VLAN manager management of internal
VLANs.
mapping Display debug messages for VLAN mapping.
notification See the debug sw-vlan notification command.
packets Display debug messages for packet handling and encapsulation processes.
redundancy Display debug messages for VTP VLAN redundancy.
registries Display debug messages for VLAN manager registries.
vtp See the debug sw-vlan vtp command.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes