B-8
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug dot1x
debug dot1x
Use the debug dot1x privileged EXEC command to enable debugging of the IEEE 802.1x authentication
feature. Use the no form of this command to disable debugging.
debug dot1x {all | errors | events | feature | packets | registry | state-machine}
no debug dot1x {all | errors | events | feature | packets | registry | state-machine}
Syntax Description
Note Though visible in the command-line help strings, the redundancy keyword is not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
Related Commands
all Display all IEEE 802.1x authentication debug messages.
errors Display IEEE 802.1x error debug messages.
events Display IEEE 802.1x event debug messages.
feature Display IEEE 802.1x feature debug messages.
packets Display IEEE 802.1x packet debug messages.
registry Display IEEE 802.1x registry invocation debug messages.
state-machine Display state-machine related-events debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show dot1x Displays IEEE 802.1xstatistics, administrative status, and operational status
for the switch or for the specified port.