Cisco IE-3000-8TC Command Reference

2-557
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
switchport access
switchport access
Use the switchport access interface configuration command to configure a port as a static-access or
dynamic-access port. If the switchport mode is set to access, the port operates as a member of the
specified VLAN. If set to dynamic, the port starts discovery of VLAN assignment based on the incoming
packets it receives. Use the no form of this command to reset the access mode to the default VLAN for
the switch.
switchport access vlan {vlan-id | dynamic}
no switchport access vlan
Syntax Description
Defaults The default access VLAN and trunk interface native VLAN is a default VLAN corresponding to the
platform or interface hardware.
A dynamic-access port is initially a member of no VLAN and receives its assignment based on the packet
it receives.
Command Modes Interface configuration
Command History
Usage Guidelines The no switchport access command resets the access mode VLAN to the appropriate default VLAN for
the device.
The port must be in access mode before the switchport access vlan command can take effect.
An access port can be assigned to only one VLAN.
The VMPS server (such as a Catalyst 6000 series switch) must be configured before a port is configured
as dynamic.
vlan vlan-id Configure the interface as a static access port with the VLAN ID of the
access mode VLAN; the range is 1 to 4094.
vlan dynamic Specify that the access mode VLAN is dependent on the VLAN Membership
Policy Server (VMPS) protocol. The port is assigned to a VLAN based on
the source MAC address of a host (or hosts) connected to the port. The switch
sends every new MAC address received to the VMPS server to get the VLAN
name to which the dynamic-access port should be assigned. If the port
already has a VLAN assigned and the source has already been approved by
the VMPS, the switch forwards the packet to the VLAN.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes