Cisco IE-3000-8TC Command Reference

2-86
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
dot1x critical (interface configuration)
dot1x critical (interface configuration)
Use the dot1x critical interface configuration command on a standalone switch to enable the
inaccessible-authentication-bypass feature, also referred to as critical authentication or the
authentication, authorization, and accounting (AAA) fail policy. You can also configure the access
VLAN to which the switch assigns the critical port when the port is in the critical-authentication state.
To disable the feature or return to default, use the no form of this command.
dot1x critical [recovery action reinitialize | vlan vlan-id]
no dot1x critical [recovery | vlan]
Syntax Description
Defaults The inaccessible-authentication-bypass feature is disabled.
The recovery action is not configured.
The access VLAN is not configured.
Command Modes Interface configuration
Command History
Usage Guidelines To specify the access VLAN to which the switch assigns a critical port when the port is in the
critical-authentication state, use the vlan vlan-id keywords. The specified type of VLAN must match the
type of port, as follows:
• If the critical port is an access port, the VLAN must be an access VLAN.
• If the critical port is a private VLAN host port, the VLAN must be a secondary private VLAN.
• If the critical port is a routed port, you can specify a VLAN, but this is optional.
If the client is running Windows XP and the critical port to which the client is connected is in the
critical-authentication state, Windows XP might report that the interface is not authenticated.
If the Windows XP client is configured for DHCP and has an IP address from the DHCP server, receiving
an EAP-Success message on a critical port might not re-initiate the DHCP configuration process.
recovery action reinitialize Enable the inaccessible-authentication-bypass recovery feature, and
specify that the recovery action is to authenticate the port when an
authentication server is available.
vlan vlan-id Specify the access VLAN to which the switch can assign a critical
port. The range is from 1 to 4094.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes