Cisco IE-3000-8TC Command Reference

2-48
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
clear mac address-table
clear mac address-table
Use the clear mac address-table privileged EXEC command to delete from the MAC address table a
specific dynamic address, all dynamic addresses on a particular interface, or all dynamic addresses on a
particular VLAN. This command also clears the MAC address notification global counters.
clear mac address-table {dynamic [address mac-addr | interface interface-id | vlan vlan-id] |
notification}
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Examples This example shows how to remove a specific MAC address from the dynamic address table:
Switch# clear mac address-table dynamic address 0008.0070.0007
You can verify that the information was deleted by entering the show mac address-table privileged
EXEC command.
Related Commands
dynamic Delete all dynamic MAC addresses.
dynamic address
mac-addr
(Optional) Delete the specified dynamic MAC address.
dynamic interface
interface-id
(Optional) Delete all dynamic MAC addresses on the specified physical port
or port channel.
dynamic vlan vlan-id (Optional) Delete all dynamic MAC addresses for the specified VLAN. The
range is 1 to 4094.
notification Clear the notifications in the history table and reset the counters.
Release Modification
12.2(44)EX This command was introduced.
Command Description
mac address-table notification Enables the MAC address notification feature.
show mac access-group Displays the MAC address table static and dynamic entries.
show mac address-table notification Displays the MAC address notification settings for all
interfaces or the specified interface.
snmp trap mac-notification Enables the Simple Network Management Protocol (SNMP)
MAC address notification trap on a specific interface.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes