Cisco IE-3000-8TC Command Reference

A-17
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix A IE 3000 Switch Bootloader Commands
reset
reset
Use the reset bootloader command to perform a hard reset on the system. A hard reset is similar to
power-cycling the switch, clearing the processor, registers, and memory.
reset
Syntax Description This command has no arguments or keywords.
Command Modes Bootloader
Command History
Examples This example shows how to reset the system:
switch: reset
Are you sure you want to reset the system (y/n)?y
System resetting...
Related Commands
Release Modification
12.2(44)EX This command was introduced.
Command Description
boot Loads and boots up an executable image and enters the command-line
interface.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes