Cisco IE-3000-8TC Command Reference

B-43
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform port-security
debug platform port-security
Use the debug platform port-security privileged EXEC command to enable debugging of
platform-dependent port-security information. Use the no form of this command to disable debugging.
debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
no debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform port-security command is the same as the no debug platform port-security
command.
Related Commands
add Display secure address addition debug messages.
aging Display secure address aging debug messages.
all Display all port-security debug messages.
delete Display secure address deletion debug messages.
errors Display port-security error debug messages.
rpc Display remote procedure call (RPC) debug messages.
warnings Display warning debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes