Cisco IE-3000-8TC - Debug Platform Sw-Bridge

B-49
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform sw-bridge
debug platform sw-bridge
Use the debug platform sw-bridge privileged EXEC command to enable debugging of the software
bridging function. Use the no form of this command to disable debugging.
debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
no debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform sw-bridge command is the same as the no debug platform sw-bridge
command.
Related Commands
broadcast Display broadcast-data debug messages.
control Display protocol-packet debug messages.
multicast Display multicast-data debug messages.
packet Display sent and received data debug messages.
unicast Display unicast-data debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.