Cisco IE-3000-8TC Command Reference

2-93
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
dot1x initialize
dot1x initialize
Use the dot1x initialize privileged EXEC command to manually return the specified
IEEE
802.1x-enabled port to an unauthorized state before initiating a new authentication session on the
port.
dot1x initialize [interface interface-id]
Syntax Description
Defaults There is no default setting.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command to initialize the IEEE 802.1x state machines and to set up a fresh environment for
authentication. After you enter this command, the port status becomes unauthorized.
There is not a no form of this command.
Examples This example shows how to manually initialize a port:
Switch# dot1x initialize interface gigabitethernet1/1
You can verify the unauthorized port status by entering the show dot1x [interface interface-id]
privileged EXEC command.
Related Commands
interface interface-id (Optional) Port to be initialized.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show dot1x [interface interface-id] Displays IEEE 802.1x status for the specified port.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes