EasyManuals Logo

Cisco IE-3000-8TC Command Reference

Cisco IE-3000-8TC
802 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #213 background imageLoading...
Page #213 background image
2-187
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
mac access-list extended
mac access-list extended
Use the mac access-list extended global configuration command to create an access list based on MAC
addresses for non-IP traffic. Using this command puts you in the extended MAC access-list
configuration mode. Use the no form of this command to return to the default setting.
mac access-list extended name
no mac access-list extended name
Syntax Description
Defaults By default, there are no MAC access lists created.
Command Modes Global configuration
Command History
Usage Guidelines MAC named extended lists are used with class maps.
You can apply named MAC extended ACLs to Layer 2 interfaces.
Entering the mac access-list extended command enables the MAC access-list configuration mode.
These configuration commands are available:
default: sets a command to its default.
deny: specifies packets to reject. For more information, see the deny (MAC access-list
configuration) MAC access-list configuration command.
exit: exits from MAC access-list configuration mode.
no: negates a command or sets its defaults.
permit: specifies packets to forward. For more information, see the permit (MAC access-list
configuration) command.
For more information about MAC extended access lists, see the software configuration guide for this
release.
Examples This example shows how to create a MAC named extended access list named mac1 and to enter extended
MAC access-list configuration mode:
Switch(config)# mac access-list extended mac1
Switch(config-ext-macl)#
This example shows how to delete MAC named extended access list mac1:
Switch(config)# no mac access-list extended mac1
name
Assign a name to the MAC extended access list.
Release Modification
12.2(44)EX This command was introduced.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals