Cisco IE-3000-8TC Command Reference

2-66
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
cluster run
cluster run
Use the cluster run global configuration command to enable clustering on a switch. Use the no form of
this command to disable clustering on a switch.
cluster run
no cluster run
Syntax Description This command has no arguments or keywords.
Defaults Clustering is enabled on all switches.
Command Modes Global configuration
Command History
Usage Guidelines When you enter the no cluster run command on a cluster command switch, the cluster command switch
is disabled. Clustering is disabled, and the switch cannot become a candidate switch.
When you enter the no cluster run command on a cluster member switch, it is removed from the cluster.
Clustering is disabled, and the switch cannot become a candidate switch.
When you enter the no cluster run command on a switch that is not part of a cluster, clustering is
disabled on this switch. This switch cannot then become a candidate switch.
Examples This example shows how to disable clustering on the cluster command switch:
Switch(config)# no cluster run
You can verify your setting by entering the show cluster privileged EXEC command.
Related Commands
Release Modification
12.2(44)EX This command was introduced.
Command Description
show cluster Displays the cluster status and a summary of the cluster to which the switch
belongs.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes