Cisco IE-3000-8TC Command Reference

B-51
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform tcam
Note Though visible in the command-line help strings, the l3 ipv6 {acl {input | output} | local | qos |
secondary}, the l3 local, and the l3 secondary keywords are not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform tcam command is the same as the no debug platform tcam command.
Related Commands
search Display supervisor-initiated TCAM-search results debug messages.
write {forw-ram | reg |
tcam}
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes