Cisco IE-3000-8TC - Page 198

2-172
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
lacp port-priority
Examples This example shows how to configure the LACP port priority on a port:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged
EXEC command.
Related Commands Command Description
channel-group Assigns an Ethernet port to an EtherChannel group.
lacp system-priority Configures the LACP system priority.
show lacp [channel-group-number]
internal
Displays internal information for all channel groups or for
the specified channel group.