Cisco IE-3000-8TC - Page 398

2-372
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show interfaces
This is an example of output from the show interfaces interface-id pruning command when pruning is
enabled in the VTP domain:
Switch# show interfaces gigibitethernet1/2 pruning
Port Vlans pruned for lack of request by neighbor
Gi1/2 3,4
Port Vlans traffic requested of neighbor
Gi1/2 1-3
This is an example of output from the show interfaces stats command for a specified VLAN interface.
Switch# show interfaces vlan 1 stats
Switching path Pkts In Chars In Pkts Out Chars Out
Processor 1165354 136205310 570800 91731594
Route cache 0 0 0 0
Total 1165354 136205310 570800 91731594
This is an example of partial output from the show interfaces status command. It displays the status of
all interfaces.
Switch# show interfaces status
Port Name Status Vlan Duplex Speed Type
Fa1/1 notconnect 1 auto auto 10/100BaseTX
Fa1/2 notconnect 1 auto auto 10/100BaseTX
Fa1/3 notconnect 1 auto auto 10/100BaseTX
Fa1/4 notconnect 1 auto auto 10/100BaseTX
Fa2/1 notconnect 1 auto auto 10/100BaseTX
Fa2/2 notconnect 1 auto auto 10/100BaseTX
Fa2/3 notconnect 1 auto auto 10/100BaseTX
Fa2/4 notconnect 1 auto auto 10/100BaseTX
Fa2/5 notconnect 1 auto auto 10/100BaseTX
Fa2/6 notconnect 1 auto auto 10/100BaseTX
Fa2/7 notconnect 1 auto auto 10/100BaseTX
Fa2/8 notconnect 1 auto auto 10/100BaseTX
<output truncated>
This is an example of output from the show interfaces status err-disabled command. It displays the
status of interfaces in the error-disabled state.
Switch# show interfaces status err-disabled
Port Name Status Reason
Gi1/2 err-disabled dtp-flap
This is an example of output from the show interfaces switchport command for a port. Table 2-24
describes the fields in the display.
Note Private VLANs are not supported in this release, so those fields are not applicable.
Switch# show interfaces gigabitethernet1/1 switchport
Name: Gi1/1
Switchport: Enabled
Administrative Mode: dynamic auto
Operational Mode: static access
Administrative Trunking Encapsulation: negotiate
Operational Trunking Encapsulation: native
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Voice VLAN: none
Administrative private-vlan host-association:10 (VLAN0010) 502 (VLAN0502)