2-375
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2    IE 3000 Switch  Cisco IOS Commands
  show interfaces
Gi0/1        1-4094
Port         Vlans allowed and active in management domain
Gi0/1        1-4
Port         Vlans in spanning tree forwarding state and not pruned
Gi0/1        1-4
This is an example of output from the show interfaces interface-id transceiver properties command:
Switch# show interfaces gigabitethernet1/1 transceiver properties
Name : Gi1/1
Administrative Speed: auto 
Operational Speed: auto 
Administrative Duplex: auto
Administrative Power Inline: N/A
Operational Duplex: auto
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
Configured Media: sfp
Active Media: sfp
Attached: 10/100/1000BaseTX SFP-10/100/1000BaseTX
This is an example of output from the show interfaces interface-id transceiver detail command:
Switch# show interfaces gigabitethernet1/3 transceiver detail
ITU Channel not available (Wavelength not available),
Transceiver is externally calibrated.
mA:milliamperes, dBm:decibels (milliwatts), N/A:not applicable.
++:high alarm, +:high warning, -:low warning, -- :low alarm.
A2D readouts (if they differ), are reported in parentheses.
The threshold values are uncalibrated.
                            High Alarm  High Warn  Low Warn   Low Alarm
        Temperature         Threshold   Threshold  Threshold  Threshold
Port     (Celsius)          (Celsius)   (Celsius)  (Celsius)  (Celsius)
------- ------------------  ----------  ---------  ---------  ---------
Gi1/2 41.5                110.0       103.0  -8.0       -12.0
                            High Alarm  High Warn  Low Warn   Low Alarm
         Voltage            Threshold   Threshold  Threshold  Threshold
Port     (Volts)            (Volts)     (Volts)    (Volts)    (Volts)
-------  ---------------    ----------  ---------  ---------  ---------
Gi1/2  3.20  4.00        3.70  3.00       2.95
                            High Alarm  High Warn  Low Warn   Low Alarm
         Current            Threshold   Threshold  Threshold  Threshold
Port     (milliamperes)     (mA)        (mA)       (mA)       (mA)
-------  -----------------  ----------  ---------  ---------  ---------
Gi1/2 31.0  84.0        70.0  4.0        2.0
         Optical            High Alarm  High Warn  Low Warn   Low Alarm
         Transmit Power     Threshold   Threshold  Threshold  Threshold
Port     (dBm)              (dBm)       (dBm)      (dBm)      (dBm)
-------  -----------------  ----------  ---------  ---------  ---------
Gi1/2  -0.0 ( -0.0)  -0.0        -0.0  -0.0       -0.0
         Optical            High Alarm  High Warn  Low Warn   Low Alarm
         Receive Power      Threshold   Threshold  Threshold  Threshold
Port     (dBm)              (dBm)       (dBm)      (dBm)      (dBm)
-------  -----------------  ----------  ---------  ---------  ---------
Gi1/2  N/A  ( -0.0) --  -0.0        -0.0  -0.0       -0.0