2-406
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show link state group
This is an example of output from the show link state group detail command:
Switch> show link state group detail
(Up):Interface up (Dwn):Interface Down (Dis):Interface disabled
Link State Group: 1 Status: Enabled, Down
Upstream Interfaces : Gi1/1(Dwn) Gi1/2(Dwn)
Downstream Interfaces : Fa2/5(Dis) Fa2/6(Dis) Fa2/7(Dis) Fa2/8(Dis)
Link State Group: 2 Status: Enabled, Down
Upstream Interfaces : Gi1/1(Dwn) Gi1/2(Dwn) Gi1/2(Dwn)
Downstream Interfaces : Fa2/5(Dis) Fa2/6(Dis) Fa2/7(Dis) Fa2/8(Dis)
(Up):Interface up (Dwn):Interface Down (Dis):Interface disabled
Related Commands Command Description
link state group Configures an interface as a member of a link-state group.
link state track Enables a link-state group.
show running-config Displays the current operating configuration. For syntax information,
select Cisco IOS Configuration Fundamentals Command Reference
for Release 12.2 > Cisco IOS File Management Commands >
Configuration File Commands.
To Next Page
Loading...
