Cisco IE-3000-8TC - Page 485

2-459
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show port-security
Examples This is an example of the output from the show port-security command:
Switch# show port-security
Secure Port MaxSecureAddr CurrentAddr SecurityViolation Security Action
(Count) (Count) (Count)
-------------------------------------------------------------------------------
Gi1/1 1 0 0 Shutdown
-------------------------------------------------------------------------------
Total Addresses in System (excluding one mac per port) : 1
Max Addresses limit in System (excluding one mac per port) : 6272
This is an example of output from the show port-security interface interface-id command:
Switch# show port-security interface gigabitethernet1/1
Port Security : Enabled
Port status : SecureUp
Violation mode : Shutdown
Maximum MAC Addresses : 1
Total MAC Addresses : 0
Configured MAC Addresses : 0
Aging time : 0 mins
Aging type : Absolute
SecureStatic address aging : Disabled
Security Violation count : 0
This is an example of output from the show port-security address command:
Switch# show port-security address
Secure Mac Address Table
-------------------------------------------------------------------
Vlan Mac Address Type Ports Remaining Age
(mins)
---- ----------- ---- ----- -------------
1 0006.0700.0800 SecureConfigured Gi1/2 1
-------------------------------------------------------------------
Total Addresses in System (excluding one mac per port) : 1
Max Addresses limit in System (excluding one mac per port) : 6272
This is an example of output from the show port-security interface gigabitethernet1/2 address
command:
Switch# show port-security interface gigabitethernet1/2 address
Secure Mac Address Table
-------------------------------------------------------------------
Vlan Mac Address Type Ports Remaining Age
(mins)
---- ----------- ---- ----- -------------
1 0006.0700.0800 SecureConfigured Gi1/2 1
-------------------------------------------------------------------
Total Addresses: 1
This is an example of output from the show port-security interface interface-id vlan command:
Switch# show port-security interface gigabitethernet1/2 vlan
Default maximum:not set, using 5120
VLAN Maximum Current
5 default 1
10 default 54
11 default 101
12 default 101
13 default 201
14 default 501