2-471
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show storm-control
This is an example of output from the show storm-control command for a specified interface. Because
no traffic-type keyword was entered, the broadcast storm control settings appear.
Switch> show storm-control gigabitethernet 1/1
Interface Filter State Upper Lower Current
--------- ------------- ---------- --------- ---------
Gi1/1 Forwarding 20 pps 10 pps 5 pps
Table 2-30 describes the fields in the show storm-control display.
Related Commands
Ta b l e 2-30 show storm-control Field Descriptions
Field Description
Interface Displays the ID of the interface.
Filter State Displays the status of the filter:
• Blocking—Storm control is enabled, and a storm has occurred.
• Forwarding—Storm control is enabled, and no storms have occurred.
• Inactive—Storm control is disabled.
Upper Displays the rising suppression level as a percentage of total available
bandwidth in packets per second or in bits per second.
Lower Displays the falling suppression level as a percentage of total available
bandwidth in packets per second or in bits per second.
Current Displays the bandwidth usage of broadcast traffic or the specified traffic type
(broadcast, multicast, or unicast) as a percentage of total available
bandwidth. This field is only valid when storm control is enabled.
Command Description
storm-control Sets the broadcast, multicast, or unicast storm control levels for the switch.
To Next Page
Loading...
