Cisco IE-3000-8TC - Page 573

2-547
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
speed
Examples This example shows how to set the speed on a port to 100 Mb/s:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# speed 100
This example shows how to set a port to autonegotiate at only 10 Mb/s:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# speed auto 10
This example shows how to set a port to autonegotiate at only 10 or 100 Mb/s:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# speed auto 10 100
You can verify your settings by entering the show interfaces privileged EXEC command.
Related Commands Command Description
duplex Specifies the duplex mode of operation.
show interfaces Displays the statistical information specific to all interfaces or to a specific
interface.