C-28
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix C IE 3000 Switch Show Platform Commands
show platform tcam
Note Though visible in the command-line help strings, the ipv6, equal-cost-route, multicast-expansion,
secondary, and usage keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
usage Display the CAM and forwarding table usage.
[[asic number [detail [invalid]] |
[index number [detail [invalid]] |
invalid | num number [detail
[invalid]] | invalid] | [invalid] |
[num number [detail [invalid]] |
invalid]]
Display information. The keywords have these meanings:
• asic number—Display information for the specified ASIC
device ID. The range is 0 to 15.
• detail [invalid]—(Optional) Display valid or invalid details.
• index number—(Optional) Display information for the
specified TCAM table index. The range is 0 to 32768.
• num number—(Optional) Display information for the
specified TCAM table number. The range is 0 to 32768.
| begin (Optional) Display begins with the line that matches the
expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified
expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(44)EX This command was introduced.
To Next Page
Loading...
Need help?
General
