Cisco IE-3000-8TC Command Reference

2-68
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
cluster standby-group
This example shows the error message when this command is executed on a cluster command switch and
the specified HSRP standby group does not exist:
Switch(config)# cluster standby-group my_hsrp
%ERROR: Standby (my_hsrp) group does not exist
This example shows the error message when this command is executed on a cluster member switch:
Switch(config)# cluster standby-group my_hsrp routing-redundancy
%ERROR: This command runs on a cluster command switch
You can verify your settings by entering the show cluster privileged EXEC command. The output shows
whether redundancy is enabled in the cluster.
Related Commands Command Description
standby ip Enables HSRP on the interface. For syntax information, select Cisco IOS IP
Command Reference, Volume 1 of 3:Addressing and Services, Release
12.2 > IP Services Commands.
show cluster Displays the cluster status and a summary of the cluster to which the switch
belongs.
show standby Displays standby group information. For syntax information, select Cisco
IOS IP Command Reference, Volume 1 of 3:Addressing and Services,
Release 12.2 > IP Services Commands.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes