Cisco WS-C6506 - Page 1102

44-18
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 44 Configuring Network Admission Control
Configuring Network Admission Control with LAN Port IP
-------- ------------- ----------- ---------- ---------------
7/1 - - - -
Port Posture URL Redirect
-------- ------------ --------------------
7/1 - -
Port Termination action Session id
-------- ------------------ --------------------------------
7/1 - -
Console> (enable)
Displaying Host-Specific Information
To display host-specific information, perform this task in normal mode:
This example shows how to display host-specific information:
Console> (enable) show eou host 9.6.2.15
HostIP HostMac Port Posture-token
--------------- ----------------- ------ --------------------
9.6.2.15 00-11-85-8d-bf-ab 2/5 Healthy
IP Address Eou State AuthType SQTimeout SessTimeout
--------------- ------------- -------- --------- -----------
9.6.2.15 authenticated eap 301 3600
Console> (enable)
Displaying EOU Authentication-Related Information
To display the following authentication-related information, perform this task in normal mode:
• clientless—Display all clientless ports
• eap—Display all ports with EAP authentication
• static—Display all hosts in the exception list
This example shows how to display authentication-related information:
Console> (enable) show eou authentication eap
Host IP HostMac Port Posture-token
--------------- ------------------ ------- --------------------
9.6.2.15 00-11-85-8d-bf-ab 2/5 Healthy
IP Address Eou State AuthType SQTimeout SessTimeout
--------------- ------------- --------- --------- -----------
9.6.2.15 authenticated eap 301 3600
Task Command
Display host-specific information. show eou host {ip | mac} value
show eou host mac_address mac_address
Task Command
Display authentication-related information. show eou authentication {clientless | eap | static}