Cisco WS-C6506 - Page 1103

44-19
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 44 Configuring Network Admission Control
Configuring Network Admission Control with LAN Port IP
Console> (enable)
Displaying the EOU Log
To display the EOU log, perform this task in normal mode:
This example shows how to display the EOU log:
Console> (enable) show eou log
LPIP-EVENT : New ip on port 3/12 9.9.150.21 from Arp-inspection
LPIP-ERROR : Failure to get host information for 9.9.143.20
LPIP-EVENT : Host 9.9.150.34 moved to EAPOUDP_TX_HELLO state
Console> (enable)
Displaying the EOU Results on a Posture-Token Basis
To display the EOU results on a posture-token basis, perform this task in normal mode:
Clearing the LAN Port IP Configuration
To clear the LAN port IP configuration and return to default values, perform this task in privileged mode:
This example shows how to clear the LAN port IP configuration and return to default values:
Console> (enable) clear eou config
This command will disable EoU on all ports and take EoU parameter values back to defaults.
Do you want to continue (y/n) [n]? y
Console> (enable)
Task Command
Display the EOU log. show eou log
Task Command
Display the EOU results on a posture-token
basis.
show eou posture-token posture_token
Task Command
Clear the LAN port IP configuration and return
to default values.
clear eou config