44-27
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 44 Configuring Network Admission Control
Configuring Network Admission Control with LAN Port IP
Displaying the Critical Status of Features on a Port
To display the critical status of features on a port, perform this task in enable mode:
This example shows how to display the critical status of features on a port:
Console> (enable) show port critical 5/1
Port Critical State Features in Critical State
----- -------------- ---------------------------
5/1 enabled dot1x, eou
Displaying the AAA Fail Policy on a Port
To display the AAA fail policy for EOU on a port, perform this task in enable mode:
This example shows how to display AAA fail policy on a port:
Console> (enable) show port eou 5/1 aaa-fail-policy
Port AAA-Fail-Policy
----- ------------------
5/1
To display the AAA fail policy for web-auth on a port, perform this task in enable mode:
This example shows how to display AAA fail policy on a port:
Console> (enable) show port web-auth 5/1 aaa-fail-policy
Port AAA-Fail-Policy
----- ------------------
5/1
Displaying RADIUS Server Information
To display RADIUS server information, perform this task in enable mode:
This example shows how to display RADIUS server information:
Task Command
Display the critical status of features on a port. show port critical mod/port
Task Command
Display the AAA fail policy for EOU on a port. show port eou mod/port aaa-fail-policy
Task Command
Display the AAA fail policy for web-auth on a
port.
show port web-auth mod/port aaa-fail-policy
Task Command
Display RADIUS server information. show radius
To Next Page
Loading...
