Cisco WS-C6506 - Page 1112

44-28
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 44 Configuring Network Admission Control
Configuring Network Admission Control with LAN Port IP
Console> (enable) show radius
Active RADIUS Server : 0.0.0.0
RADIUS Deadtime : 0 minutes
RADIUS Key :
RADIUS Retransmit : 2
RADIUS Timeout : 5 seconds
Framed-Ip Address Transmit : Disabled
RADIUS Framed MTU : 1000 bytes
RADIUS Keepalive : Enabled
RADIUS Keepalive Timer : 0 minutes
RADIUS Autoinitialize Critical: Disabled
RADIUS-Server Status Auth-port Acct-port Resolved IP Addrese
-------------------------------- ------- --------- --------- -------------------
Displaying the MAC Authorization Bypass Settings on a Port
To display the MAC authorization bypass settings on a port, perform this task in enable mode:
This example shows how to display the MAC authorization bypass settings on a port:
Console> (enable) show port mac-auth-bypass 5/1
Port Mac-Auth-Bypass State MAC Address Auth-State Vlan
----- --------------------- ----------------- ----------------- -----
5/1 Disabled - - 1
Port Termination action Session Timeout Shutdown/Time-Left
----- ------------------ --------------- ------------------
5/1 - 3600 NO -
Port PolicyGroups
----- -----------------------------------------------------
5/1 -
Port Critical Critical-Status
----- -------- ---------------
5/1 Disabled -
Console> (enable)
Displaying the Web Authorization Settings on a Port
To display web authorization settings on a port, perform this task in enable mode:
This example shows how to display the web authorization settings on a port:
Console> (enable) show port web-auth 5/1
Task Command
Display the MAC authorization bypass settings
on a port.
show port mac-auth-bypass mod/port
Task Command
Display the web authorization settings on a
port.
show port web-auth mod/port