51-32
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 51 Configuring Multicast Services
Configuring RGMP on the Switch
Enabling and Disabling RGMP
Note To enable RGMP, you must have IGMP snooping enabled.
To enable or disable RGMP, perform one of these tasks in privileged mode:
This example shows how to enable RGMP:
Console> (enable) set rgmp enable
RGMP enabled.
Console> (enable)
This example shows how to disable RGMP:
Console> (enable) set rgmp disable
RGMP disabled.
Console> (enable)
Displaying RGMP Group Information
Use these commands to display all multicast groups that were joined by one or more RGMP-capable
routers and to display the count of multicast groups that were joined by one or more RGMP-capable
routers.
To display RGMP group information, perform one of these tasks in privileged mode:
This example shows how to display RGMP group information:
Console> (enable) show rgmp group
VlanDest MAC/Route DesRGMP Joined Router Ports
---------------------------------------------------------------------------------------
1 01-00-5e-00-01-285/1,5/15
1 01-00-5e-01-01-015/1
2 01-00-5e-27-23-70*3/1, 5/1
Total Number of Entries = 3
‘*’ - Configured
Console> (enable)
Console> (enable) show rgmp group count 1
Total Number of Entries = 2
Task Command
Enable RGMP. set rgmp enable
Disable RGMP. set rgmp disable
Task Command
Display all multicast groups that were joined by
one or more RGMP-capable routers.
show rgmp group [mac_addr] [vlan_id]
Display the count of multicast groups that were
joined by one or more RGMP-capable routers.
show rgmp group count [vlan_id]
To Next Page
Loading...
Need help?
General