Cisco WS-C6506 - Page 1225

51-33
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 51 Configuring Multicast Services
Configuring RGMP on the Switch
Displaying RGMP VLAN Statistics
To display the RGMP statistics for a given VLAN, perform this task in privileged mode:
This example shows how to display the RGMP statistics for a specified VLAN:
Console> (enable) show rgmp statistics 23
RGMP enabled
RGMP Statistics for vlan <23>:
Receive:
Valid pkts:20
Hellos:10
Joins:5
Leaves:5
Byes:0
Discarded:0
Transmit:
Total Pkts:10
Failures:0
Hellos:10
Joins:0
Leaves:0
Byes:0
Console> (enable)
Displaying RGMP-Capable Router Ports
This command displays the detected RGMP-capable router ports. A “+” in front of the port indicates that
it is an RGMP-capable router.
To display the RGMP-capable router ports, perform this task in privileged mode:
This example shows how to display the ports that are connected to the RGMP-capable routers:
Console> (enable) show multicast router
Port Vlan
-------------- ----------------
2/2 + @ 40
8/48 @ 10
16/1 + @ 200-201
Total Number of Entries = 3
'*' - Configured
'+' - RGMP-capable
'#' - Channeled Port
'$' - IGMP-V3 Router
'@' - IGMP-Querier Router
Console> (enable)
Task Command
Display the RGMP statistics for a specified
VLAN.
show rgmp statistics [vlan]
Task Command
Display the RGMP-capable router ports. show multicast router [igmp | rgmp] [mod/port]
[vlan_id]