51-34
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 51 Configuring Multicast Services
Configuring RGMP on the Switch
This example shows how to display only the RGMP-capable router ports:
Console> (enable) show multicast router rgmp
Port Vlan
-------------- ----------------
2/2 + @ 40
16/1 + @ 200
Total Number of Entries = 2
'*' - Configured
'+' - RGMP-capable
'#' - Channeled Port
'$' - IGMP-V3 Router
'@' - IGMP-Querier Router
Console> (enable)
Clearing RGMP Statistics
This command clears the stored RGMP statistics.
To clear the RGMP statistics, perform this task in privileged mode:
This example shows how to clear the RGMP statistics:
Console> (enable) clear rgmp statistics
RGMP statistics cleared.
Console> (enable)
RGMP-Related CLI Commands
This command enables or disables the RGMP-related commands from the router.
To enable or disable RGMP, perform one of these tasks in configuration mode:
This command enables or disables RGMP debugging.
To enable or disable RGMP debugging, perform one of these tasks in privileged mode:
Task Command
Clear the RGMP statistics. clear rgmp statistics
Task Command
Enable RGMP. Router(config)# ip rgmp
Disable RGMP. Router(config)# no ip rgmp
Task Command
Enable RGMP debugging. Router# debug ip rgmp [group-name |
group-address]
Disable RGMP debugging. Router# no debug ip rgmp [group-name |
group-address]
To Next Page
Loading...
